Migatronic FOCUS STICK 120 E PFC Guide De L'utilisateur page 5

Connection and operation
Warning
Read warning notice and
instruction manual carefully
prior to initial operation and
save the information for later
use.
Permissible installation
Mains connection
Connect the machine to the correct mains supply. Please
read the type plate (U ) on the rear side of the machine.
1
0
l
1
Important!
In order to avoid destruction of plugs
and cables, good electric contact
is required when connecting earth
cables and welding hoses to the
machine.
2
5
4
3
1. Mains connection
2. Power switch
3. Connection of earth clamp or electrode holder
4. Connection of earth clamp or electrode holder
5. Welding voltage
The welding voltage indicator is illuminated for
reasons of safety and in order to show if there is
voltage at the output taps or electrode.
Connection of electrode holder for MMA
The electrode holder and earth cable are connected to
plus connection (3) and minus connection (4). Observe
the instructions from the electrode supplier when
selecting polarity.
Switch on, press, weld
• Switch on the welding machine on the main switch (2)
• Adjust the welding current
• The machine is now ready to weld
Fault symbols
Temperature error
The indicator flashes, when the power source is
overheated.
Leave the machine on until the built-in fan has cooled it
down.
5
2
1