Publicité
Fig. 7.1
Fig. 7.2
Fig. 8
Fig. 9
62
Length latch assembly fig. 7.1-7.2
Push the length latch track between the clamping block
and the set pipe on the latch and tighten this with the
two wing screws.
Please note the two possibilities.
• For a higher stop: read this at the front, fig. 7.1.
• For a lower stop: read this on the scale at the back
fig.7.2
Cross cut gauge assembly, fig. 8
• Put the stop track with the two knurled head screws
in the niche of the swinging arm and clamp these
down tight.
• The cross cut gauge can be used on the left or the right
side of the saw blade in the groove.
Storing the pusher, fig. 9
Place the pusher after each use back into its storage
place.
Publicité
