Publicité
52
terials are not suitable for laser, since the reflecting
surface could return the beam to the operator.
• Do not exchange the laser light unit for another type.
Repairs have to be conducted by the manufacturer or
an authorised specialised company.
Caution: You must only apply the regulation and adjust-
ment tools and methods described in this manual.
Non-observance can lead to dangerous radiation.
Accessories
Only purchase accessories from your authorised special-
ised dealer.
m Use only as authorized
The machine corresponds to the valid EC guideline.
• The circular sawbench is defined as a transportable
machine.
• To transport the machine, grasp the table firmly at
the front and at the rear using both hands and lift the
machine.
• If an original base is not used, the machine must be
placed firmly upon a stable stand resembling a table.
The working height should be 850 mm.
• The machine's workstation is in front of the machine
to the left of the saw blade.
• The machining range and surrounding areas of the
machine must be clear of interfering foreign matter to
prevent accidents occurring.
• Workpieces must be completely free of foreign objects,
i.e. nails or screws.
• Before the machine is put into operation it must be
connected to a dust extractor with a flexible, non-
flammable suction hose. The suction should switch on
automatically when the machine is switched on.
• When
used
in
enclosed
must be connected to a vacuum exhaust unit.
Use the Woodster dust extractor ha 3200 or ha 2600
to remove match wood or saw dust. The vacuum sup-
port flow rate must be 20 m/s. Subatmospheric pres-
sure 1200 Pa.
• The Woodster automatic switching unit is available as
a special accessory.
Type ALV 2
Art. No. 7910 4010
Hz
The vacuum exhaust unit automatically switched on af-
ter a 2-3 second delay after the machine tool is turned
on. This avoids overloading the circuit fuse.
After turning off the machine tool, the vacuum ex-
haust unit remains on for an additional 2-3 sec-
onds and is then automatically switched off.
Remaining dust is thereby removed by vacuum exhaust,
as required by German regulations governing hazardous
materials. This results in savings in electricity con-
sumption and reduces noise levels, as the vacuum ex-
haust unit is on only during machine tool operation.
• For work in commercial spaces, an appropurate dust
extractor must be used. Do not remove or shut off
vacuum exhaust systems or dust removers while ma-
chine tools are operating.
• The circular sawbench is designed exclusively for the
rooms,
the
machine
230 V / 50
Publicité
