Daily Use - Progress PAS6060E Manuel D'installation Et D'utilisation

Display
-
Residual heat indicator
Warning! The risk of burns from
residual heat!

DAILY USE

Activation and deactivation
Touch for 1 second to activate or deac-
tivate the appliance.
Automatic Switch Off
The function deactivates the appliance
automatically if:
• All cooking zones are deactivated (
• You do not set the heat setting after you
activate the appliance.
• You spill something or put something on
the control panel for more than 10 sec-
onds, (a pan, a cloth, etc.). An acoustic
signal sound some time and the appli-
ance deactivates. Remove the object or
clean the control panel.
• You do not deactivate a cooking zone or
change the heat setting. After some time
comes on and the appliance deacti-
vates. See below.
• The relation between heat setting and
times of the Automatic Switch Off func-
tion:
•
, - — 6 hours
•
- — 5 hours
•
— 4 hours
•
- — 1.5 hours
The heat setting
Touch to increase the heat setting.
Touch to decrease the heat setting. The
display shows the heat setting. Touch
The cooking zone operates.
The Keep Warm function operates.
The Automatic Heat Up function operates.
There is a malfunction.
The cooking zone is still hot (residual heat).
Lock / The Child Safety Device operates.
The Automatic Switch Off operates.
).
Description
and at the same time to deactivate the
cooking zone.
Activation and deactivation of the outer
rings
You can adjust the surface you cook to the
dimension of the cookware.
To activate the outer ring touch the sensor
field / . The indicator comes on.
Do the procedure again to deactivate the
outer ring. The indicator goes out.
Automatic Heat Up
You can get a necessary heat setting in a
shorter time if you activate the Automatic
Heat Up function. This function sets the
highest heat setting for some time (see the
diagram), and then decreases to the neces-
sary heat setting.
To start the Automatic Heat Up function the
cooking zone must be cold (no
display). Touch
again and again until the necessary heat
setting comes on. After 3 seconds
comes on in the display.
To stop the function, touch
progress 17
in the
of the cooking zone
.