HASE Sendai 110 Manuel D'utilisation page 48

Technical Data Sendai 135/175
The Sendai 135/175, certified in compliance with DIN-EN 13240 and Art. 15 a B-VG
(Austria), can only be operated when the fire box is closed. Conforms with the DIBt
(Deutschen Institut für Bautechnik/German Institute for Building Technology) approv-
al criteria for direct vent fireplaces for solid fuels. Multiple connections to the chim-
ney are possible, see point 4. "Connection of Multiple Devices in Direct Vent
Operation". DIBt approval number: Z-43.12-396 / Typ FC41x and FC51x
The following data applies to the chimney characteristics in accordance with
EN 13384-1 / 2:
Combustion Values*
Nominal Thermal Output
Room heating output
Exhaust gas temperature
Efficiency
Particulate
OGC
NO
X
CO content at 13% O
2
Waste Gas Mass Flow Rate
Waste Gas Outlet Temp.
Min. Supply Pressure at Nominal Thermal Output**
Min. required combustion air volume
* Test bench performance and values
Depending on the insulation of the building, the nominal thermal output of 6 kW indi-
cated on 20 - 80 m² (subject to change).
Dimensions: Height
Stove 133/175 - 220 cm
Fire box 61 cm
48
Wood
6 kW
6.6 kW
236 ˚C
83.5 %
9 mg/Nm³
66 mg/Nm³
99 mg/Nm³
817 mg/Nm³
5.33 g/s
299 ˚C
Pa
12
25 m³/h
Width Depth
37 cm 41 cm
21 cm 27 cm
Weight Sendai 135
Weight Sendai 175 (without heat retaining block ) / Additional module
Weight 1x heat retaining block flue pipe conection top / rear
¹Vertical flue pipe length
Flue pipe diameter
Pipe diameter of Hase ventilation system**
Front view Sendai 175:
37
Top view Sendai 175:
** For separate air supply in low-energy houses and
the stove is installed.
140 kg
163 / 15 kg
63 / 52,5 kg
min. 25 cm
15 cm
10 cm
Side view Sendai 175:
17,5
Inst. of Hase air system below
Dimensions in cm
insufficient combustion air supply in the room where