Publicité
Les langues disponibles
Les langues disponibles
Important:
Damages caused by the disregard of this user manual are not subject to warranty. The dealer
will not accept liability for any resulting defects or problems.
Pay attention to all warning labels and instructions printed on the exterior of your ANTARI Fog Cooler
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it
on immediately. The arising condensation water might damage your device. Leave the device switched off
until it has reached room temperature.
This device falls under protection-class I. The power plug must only be plugged into a protection class I
outlet.
Always plug in the power plug least. Make sure that the power-switch is set to OFF position before you
connect the device to the mains.
Never let the power-cord come into contact with other cables! Handle the power-cord and all connections
with the mains with particular caution!
Make sure that the available voltage is not higher than stated on the rear panel.
Make sure that the power-cord is never crimped or damaged by sharp edges. Check the device and the
power-cord from time to time.
Always disconnect from the mains, when the device is not in use or before cleaning it. Only handle the
power-cord by the plug. Never pull out the plug by tugging the power-cord.
Please consider that damages caused by manual modifications to the device are not subject to warranty.
Keep away children and amateurs!
OPERATING DETERMINATIONS
This device is a special effect machine for creating floor fog. This product is only allowed to be operated with
an alternating voltage of 230 V, 50 Hz and was designed for indoor use only.
Do not shake the device. Avoid brute force when installing or operating the device.
When choosing the installation-spot, please make sure that the device is not exposed to extreme heat,
moisture or dust. There should not be any cables lying around. You endanger your own and the safety of
others!
Ideal operating temperature is 10 - 30 degrees Celsius.
After moving or transporting this unit, wait five minutes before operating.
Input fog must be clean. Contaminated fog may damage internal parts.
Keep this device dry.
Keep fog cooler upright. Do not tilt this device. Angle of inclination may not exceed 10 degrees.
This machine is not water- or splash-proof. If moisture, water, or fog liquid gets inside the housing,
immediately unplug the unit and contact a service technician or your ANTARI dealer before using it again.
Locate the fog cooler in a well-ventilated area. Never cover the unit's vents. The fog cooler is best installed 1
meter away from all objects.
11
Publicité
