Main Power And Control Panel Power - Canon imageRUNNER ADVANCE 6275i Guide De L'utilisateur

Main Power and Control Panel Power

This section describes how to use the main power switch and the Energy Saver key.
Do not connect or disconnect the power cord with wet hands, as this may result in electrical shock.
● How to Turn ON the Main Power
Make sure that the power plug is fi rmly inserted into the power outlet, and then turn ON the main power of the machine
following the procedure below.
● Shutting Down the Machine
This machine performs a procedure to protect the hard disk when the machine is shut down. This enables the machine to be
shut down safely, even if there are any jobs being processed, or a MEAP application is running while the machine is shutting
down.
● Energy Saver Key
If the machine is idle for a certain period of time, the machine will enter the Auto Sleep mode to minimize energy
consumption. Press to cancel the Sleep mode and resume normal machine operations.
Control Panel (Flat)
40 Flow of Basic Operations
1. Open the main power switch cover.
2. Press the main power switch to the "I" side.
3. Close the main power switch cover.
•
If you are using a login service, log in using the procedure for the login service you are
using.
•
If the main power indicator on the control panel does not light even though the main
power switch is ON, be sure to check the breaker to see if it is OFF.
•
If you want to turn OFF the main power and then back ON again, wait for at least 10
seconds after the main power indicator is turned OFF before turning ON the main
power.
1. Open the main power switch cover.
2. Press the main power switch to the " " side.
3. Close the main power switch cover.
•
Do not turn the main power OFF while using Fax/I-Fax function. Sending or receiving
I-fax or fax documents cannot be done when the main power is turned OFF.
•
If the message <Backing up stored data from the Remote UI...> is displayed on the
touch panel display, do not turn the main power OFF. This may cause the machine to
fail to back up the stored data.
•
Data stored in the machine may be damaged if the Advanced Space is accessed by
another imageRUNNER ADVANCE machine or a computer immediately before the
machine shuts down.
•
The machine may take some time to completely shutdown. Do not unplug the power
cord until the main power indicator of the machine is OFF.
•
If the main power is turned OFF during scanning or printing, a paper jam may occur.
Upright Control Panel-B1
2