Adjusting a Paper Drawer to Hold
a Diff erent Paper Size
If you want to load a diff erent size paper into a paper
drawer, follow the procedure described below to adjust
the paper drawer guides.
When handling paper, take care not to cut your hands
on the edges of the paper.
1
Remove the paper loaded in the paper
drawer.
1. Press the open button on the paper drawer for which
you want to adjust the paper size.
2. Grip the handle, and pull out the paper drawer until it
stops.
3. Remove all of the remaining paper.
2
Adjust the position of the paper drawer
guides.
1. Slide the left guide while squeezing it on the top to
align it with the mark for the desired paper size.
2. Slide the front guide while squeezing it on the top to
align it with the mark for the desired paper size.
IMPORTANT
Slide the guides until they click into place. If the left guide
and front guide are not aligned correctly, the paper size
will not correctly appear on the touch panel display. It
is also necessary to adjust the guides correctly to avoid
causing a paper jam, dirty prints, or making the inside of
the machine dirty.
52
Routine Maintenance
3
Load the appropriate size paper into the
paper drawer.
1. Make sure that the paper size setting of the paper
drawer matches the size of the paper to load in the
paper drawer.
2. Load the paper stack against the right wall of the paper
drawer.
4
Change the paper drawer's paper size plate
to match the new paper size.
1. Open the inside cover of the paper drawer, and lift up
the plate.
2. Rotate the plate so that the new paper size is on the
right side of the plate.
3. Insert the plate straight down, and close the inside
cover.
NOTE
The paper size that cannot be used depending on the
model and settings is also listed on the paper size plate.
5
Gently push the paper drawer back into
the machine until it clicks into place in the
closed position.
When returning the paper drawer to its original
position, be careful not to get your fi ngers caught, as
this may result in personal injury.
3