Victron energy BlueSolar MPPT 150/35 Mode D'emploi page 3

1. General Description
1.1 Charge current up to 35 A and PV voltage up to 150 V
The BlueSolar MPPT 150/35 charge controller is able to charge
a lower nominal-voltage battery from a higher nominal voltage
PV array.
The controller will automatically adjust to a 12V, 24V or a 48V
nominal battery voltage.
1.2 Ultra-fast Maximum Power Point Tracking (MPPT)
Especially in case of a clouded sky, when light intensity is
changing continuously, an ultra fast MPPT controller will
improve energy harvest by up to 30% compared to PWM charge
controllers and by up to 10% compared to slower MPPT
controllers.
1.3 Advanced Maximum Power Point Detection in case of
partial shading conditions
If partial shading occurs, two or more maximum power points
may be present on the power-voltage curve.
Conventional MPPT's tend to lock to a local MPP, which may
not be the optimum MPP.
The innovative BlueSolar algorithm will always maximize energy
harvest by locking to the optimum MPP.
1.4 Outstanding conversion efficiency
No cooling fan. Maximum efficiency exceeds 98%. Full output
current up to 40° C (104°F).
1.5 Flexible charge algorithm
Eight preprogrammed algorithms, selectable with a rotary
switch.
1.6 Extensive electronic protection
Over-temperature protection and power derating when
temperature is high.
PV short circuit and PV reverse polarity protection.
PV reverse current protection.
1.7 Internal temperature sensor
Compensates absorption and float charge voltages for
temperature.
1