E -Short Cut Function; Maintenance And Cleaning; Cleaning; A - Cleaning The Appliance And The Remote Control - Olimpia splendid DOLCECLIMA EASY 10P Mode D'emploi

3.12.e Short Cut function
• This function can be activated only from the remote control.
a. When the appliance is running in any of its modes, press the key "SHORT CUT" on the remote control
and the appliance automatically configures itself to "AUTO" with a set temperature of 26°C (80 f).

4 - MAINTENANCE AND CLEANING

Before proceeding with any maintenance and cleaning
intervention, always make sure you disconnected the
power plug from the power socket.
Do not touch the metal parts of the appliance when you
remove the filter.
There is a risk of injury due to the sharp metal edges.
Do not use water to clean the internal parts of the air conditioner.
Exposure to water can ruin the isolation, with the risk of electric shocks.

4.1 - CLEANING

4.1.a - Cleaning the appliance and the remote control

a. use a dry cloth to clean the appliance and the remote control.
b. it is possible to use a cloth moistened with cold water to clean the appliance in case it's very dirty.
Do not use a chemically treated or antistatic cloth to clean the appliance.
Do not use gasoline, solvent, polish or similar solvents.
These products could cause the breakage or deformation of the plastic surface.

4.1.b - Servicing and cleaning the air filters

To ensure the indoor air is filtered correctly and to guarantee that your air conditioner runs efficiently, it is
vital to clean the air filters regularly.
A dirty air filter reduces the cooling capacity of the appliance.
Please clean the filter once every 2 weeks.
a. Stop the air conditioner and disconnect the power supply.
b. Remove the filter from the conditioner (fig.18).
c. Wash the filters with a water jet aimed at the side opposite the accumulation of dust. If the dirt is particularly
difficult to remove (such as grease or other types of deposit), first immerge the filter in a solution of water
and a neutral detergent.
d. Shake off any water before reinserting the filters (fig.19).
EN - 30