Table des Matières
Publicité
For storage and transport purposes, some
components of the machine may not be installed
in the factory and have to be assembled after
unpacking. Follow the instructions below.
Unpacking and completing the assembly
should be done on a flat and stable surface,
with enough space for machine handling
and its packaging, always making use of
suitable equipment. Do not use the machine
until all the indications provided in the
"ASSEMBLY" section have been carried out.
4.1 ASSEMBLY COMPONENTS
The packaging includes assembly components.
4.1.1
Unpacking
1. Cautiously open the packaging, paying
attention not to lose components.
2. Consult the documentation in the
box, including these instructions.
3. Remove all the unassembled
parts from the box.
4. Remove the machine from the box.
5. Dispose of the box and packaging in
compliance with local regulations.
4.2 ASSEMBLY OF THE GUIDE
BAR AND TOOTHED CHAIN
Always wear heavy-duty gloves when
handling the bar and chain. Mount the
bar and chain very carefully so as not to
impair the safety and efficiency of the
machine. If in doubt, contact your dealer.
Perform all operations after
removing the battery.
1. Using the supplied wrench, unscrew
the nuts (Fig. 3.A) and remove the
chain guard (Fig. 3.B), to access
the drive pinion and bar seat.
2. Mount the bar (Fig. 4.A) by inserting
the stud bolts (Fig. 4.B) in the groove
(Fig. 4.C) and push it towards the
back of the machine body.
3. Mount the chain around the drive pinion (Fig.
5.A) and along the bar guide, being careful
to follow the sliding direction (Fig. 5.B).
4. If the tip of the bar is equipped with
a nose sprocket, make sure the
drive links are correctly inserted in
the sprocket rims (Fig. 6.A).
Direction in which
the chain runs
5. Check that chain tension adjuster pin
(Fig. 5.C) is fitted properly in the hole on
the bar; if it isn't, turn the chain tension
adjuster screw (Fig. 5.D) using a screwdriver
until the pin is completely inserted.
6. Replace the guard without
fully tightening the nuts.
7. Turn the chain tension adjuster screw (Fig.
5.D) to achieve the desired tension (Fig. 7).
8. Raise the bar and tighten the guard nuts
securely using the wrench (Fig. 8.A).
4.2.1 Checking the chain tension
Check the chain tension.
The tension is correct when the drive links
do not slip out of the chain guides if you hold
the chain in the middle of the bar (Fig. 7).
5. CONTROLS
5.1 SAFETY BUTTON (ACTIVATION
/ DEACTIVATION DEVICE)
Press this button to activate and deactivate
the machine electric circuit (Fig. 9.A).
Light OFF: the electric circuit
is completely deactivated.
Green light: the machine
electric circuit is activated. The
machine is ready for use.
Blinking red light: operating fault.
See chapter 15. troubleshooting.
IMPORTANT Do not keep your finger
on the button when moving the machine to
avoid accidentally enabling the machine.
5.2 THROTTLE CONTROL LEVER
Used to start and regulate the
chain speed (Fig. 10.A).
The throttle control lever (Fig. 10.A) can
only be used if the throttle break lever is
pressed simultaneously (Fig. 10.B).
The correct running speed will be
achieved by pressing the throttle control
lever (Fig. 10.A) as far as possible.
5.3 THROTTLE BRAKE BUTTON
The throttle brake button (Fig. 10.B) allows the
throttle control lever to be used (Fig. 10.A).
EN - 7
Publicité
Table des Matières
