Table Des Matières - Stiga CS 80 Li Manuel D'utilisation

WARNING!: READ THE INSTRUCTION BOOKLET THOROUGHLY
EN
BEFORE USING THE MACHINE. Keep for future reference
INDEX
1. GENERAL INFORMATION .......................... 1
2. SAFETY REGULATIONS ............................. 2
3. GETTING TO KNOW THE MACHINE ......... 5
3.1 Description of the machine and planned
use ........................................................ 5
3.2 Safety signs .......................................... 5
3.3 Identification label ................................ 6
3.4 Main components ................................. 6
4. ASSEMBLY .................................................. 6
4.1 Assembly components ......................... 7
4.2 Assembly of the guide bar and toothed
chain ..................................................... 7
5. CONTROLS ................................................. 7
5.2 throttle control lever .............................. 7
5.3 Throttle brake button ............................ 7
5.4 Chain brake .......................................... 8
6. USING THE MACHINE ................................ 8
6.1 Preparation ........................................... 8
6.2 Safety checks ....................................... 8
6.3 Startup .................................................. 9
6.4 Operation .............................................. 9
6.5 Stop .....................................................11
6.6 After operation .....................................11
7. ROUTINE MAINTENANCE .........................11
7.1 General information .............................11
7.2 Battery ................................................ 12
7.3 Topping up the chain oil tank .............. 12
7.4 Cleaning ............................................. 12
7.5 Chain catcher ..................................... 13
7.6 Nuts and bolts .................................... 13
8. EXTRAORDINARY MAINTENANCE ......... 13
8.1 Machine and bar lubrication holes .... 13
8.2 Chain drive sprocket ........................... 13
8.3 Maintenance of the toothed chain ...... 13
8.4 Guide bar maintenance ...................... 13
9. STORING THE MACHINE ..........................14
9.1 Storing the machine ............................14
9.2 Storing the battery ...............................14
10. HANDLING AND TRANSPORTATION .......14
11. ASSISTANCE AND REPAIRS .....................14
12. WARRANTY COVERAGE ..........................14
13. MAINTENANCE TABLE ............................. 15
14. CHAIN MAINTENANCE TABLE ................. 15
15. PROBLEM IDENTIFICATION..................... 15
16. ATTACHMENTS ON REQUEST .................17
16.1 Batteries ..............................................17
16.2 Battery charger ....................................17
16.3 Battery holder harness ........................17
16.4 BARS AND CHAINS ............................17
1. GENERAL INFORMATION
1.1 HOW TO READ THE MANUAL
Some paragraphs in the manual contain
important information regarding safety and
operation and are emphasized in this manner:
NOTE or IMPORTANT these give details
or further information on what has already been
said, and aim to prevent damage to the machine.
The symbol highlights danger.
Non-compliance with the warning
could lead to personal and/or third
party injury and or damage.
The paragraphs highlighted in a square
with grey spots indicate the optional
characteristics not on all models
documented in this manual. Check if
the characteristic is on this model.
Whenever reference is made to a
position on the machine "front", "back",
"left" or "right" hand side, this refers to
the operator's working position.
1.2 REFERENCES
1.2.1 Figures
The figures in these instructions for
use are numbered 1, 2, 3, etc.
Components shown in the figures
are marked A, B, C, etc.
A reference to component C in figure 2 is
written: "See fig. 2.C" or simply "(Fig. 2.C)".
The figures are given as a guide only. The
actual parts may vary from those shown.
1.2.2 Titles
The manual is divided into chapters and
paragraphs. The title of paragraph "2.1
Training" is a sub-title of "2. Safety regulations".
References to titles or paragraphs are marked
with the abbreviation chap. or par. and the
relevant number. Example: "chap. 2" o "par. 2.1".
EN - 1