Angelo Po 1G1FA0GV Manuel D'utilisation Et D'installation page 54

REPLACING THE FAN MOTOR
To carry out this operation, proceed as follows.
1 - Turn off the gas supply tap.
2 - Open the oven door (A).
3 - Undo the screws (B) and remove the guard (C).
4 - Unscrew the screws (D).
5 - Pull off and extract the motor support (E) with-
out pulling the electric cable.
IT
DECOMMISSIONING AND SCRAPPING THE APPLIANCE
When decommissioning the appliance, a series of
GB
procedures must be carried out to ensure that the
appliance and its components are not a hindrance
DE
and are not easily accessible.
To ensure that the appliance cannot constitute haz-
ards for people or the environment, all energy
FR
sources (electricity, etc.) must be disconnected and
rendered unusable, and any liquids present must
ES
be drained (lubricants, fluids, etc.).
Place the appliance in a suitable area which is not
easily accessible, with barriers to prevent anyone
from accessing it.
English
A
F
C B
6 - Disconnect the connector (F).
7 - Remove the fan (G).
8 - Undo the screws (H), remove the motor (L) and
replace it.
9 - Restore the initial conditions after completing
the operation.
D
G
E
When scrapping, sort all components by chemical
characteristics and dispose of them separately in
accordance with the relevant legal requirements.
Important
Do not dump non-biodegradable products,
lubricating oils, and non-metallic compo-
nents (rubber, PVC, resins, etc.) in the envi-
ronment. Dispose of them in compliance
with the relevant laws.
- 26 -
H
L
IDM-39604016500.tif