Storch Power HD Krake Mode D'emploi page 51

Technical specifications for standard cleaning attachment FLEX:
Overall width 280 mm, Overall length 200 mm, Working width approx. 230 mm
Working pressure 60 - 200 bar.
Water infeed max. 20 l / min.
Water temperature max. 80° C
Scope of delivery of your Power HD Krake:
Standard cleaning attachment FLEX complete with sealing brushes
Suction hose 10m
Discharge hose 10 m
Suction unit complete with filter, immersion pump and trolley
Connecting lead with ground fault circuit interrupter protected plug
Instruction manual
SAFETY CHECKS:
ENSURE COMPLIANCE WITH APPLICABLE NATIONAL LEGISLATION.
General functional description:
The Power HD Krake captures the water blasted onto a facade (or any other surface, walls, ceilings, floors) by a high
pressure cleaner: the solid particles contained in the waste water are filtered out as of a particle diameter of 0.21 mm
so that the treated water can typically (depending on the local waste water authority's regulations) be discharged into
a waste water channel in an environmentally friendly way. A high-pressure hose with the machine is attached to the
high-pressure cleaner and the cleaning attachment which blasts the water via an internal rotation nozzle onto the sur-
face to be cleaned. The suction unit creates a vacuum in the cleaning attachment so that the water is extracted directly
into the suction unit through the suction hose without any notable volume of water escaping from the cleaning attach-
ment.
This makes it possible to use the high pressure cleaner for interior work (e.g. stairwells / churches) without any addi-
tional preparation. The suction unit can be used with one or two motors depending on the required extraction perform-
ance. To allow this to happen, the motors are switched separately at the main switch. The waste water is filtered in
the suction unit using a filter (210 - 400 mµ available) and then continually discharged via the discharge hose by the
integrated immersion pump.
CAUTION
Use of the Power HD Krake is prohibited if materials with the following hazard symbols are processed:
Explosive
The Power HD Krake's motors are not protected against explosion and may ignite materials marked as such. Please
always refer to the material manufacturer's MSDS. Never use materials with a flash point below 21°C.
CAUTION
The diameter of the discharge hose should not be below ¾". The machine is supplied with a 400 my reusa-
ble filter.
Kite marks/Waste water regulations
IP 44
Extremely / highly flammable
51 Translation of the original instruction