UFESA AC6250 Mode D'emploi page 11

use of the appliance in a
safe way and understand
the hazards involved.
Children shall not play
with the
Cleaning and
maintenance shall not be
made by children without
supervision.
• At the end of its life, the
vacuum cleaner should
be disposed of in an
appropriate manner.
• Cable repairs
replacements must be
carried out exclusively by
an authorized technical
service centre.
SUCTION SYSTEM
This appliance operates without a dust bag
using cyclone-tech technology. To do this just
attach cyclone-tech unit to the appliance.
SWITCHING ON
- Insert the hose handgrip (4) into the suction
hole (6) so that it clicks into position.
Pressing down the release button will help you
to insert or remove the hose (3). Fig. 1
- Attach the telescopic tube (2) to the hose
handgrip (4), and adjust the length to suit the
user. Fig. 2
- Fit the floor brush (1), accessory number 15,
16, 17, 18, 19 to the vacuum tube Fig. 3. The
accessary parts 17, 18, 19 can also be affixed
to the hose handgrip Fig. 4.
- Holding the power cord by the plug, pull out
the required length and plug it into the mains
socket. Fig. 5
- Press the On/Off pedal (7), Fig. 6. The intensity can
be regulated from the hose handgrip. Opening
the suction regulating flap (5) reduces suction,
whereas closing it increases suction. Fig. 7
- You can use the parking aid (11) on the back
of the vacuum cleaner if you wish to stop
vacuuming for a short while. Slide the catch
on the brush into the groove at the rear of the
appliance.
appliance. Fig. 8
- The wheels and 360° swivel joint and the
user
carrying handle, make this vacuum cleaner
extremely mobile.
WHEN FINISHED
When you have finished using the appliance,
press the On/Off pedal (7). Press the automatic
cable rewind pedal (9) to wind the cable back
in. Fig. 9
MAINTAINING THE CYCLONE-
TECH UNIT AND FILTERS
When suction power decreases considerably
and the container full indicator (8) lights up, this
means that the container is full or that the filters
are clogged.
Follow the instructions for emptying the dust
and container (22) and cleaning the filters.
Emptying and cleaning the dust container
(22)
The dust container (22) must be emptied after
each use, do not let the dust exceed the "max"
level line marked on the container.
- To do this, press the cyclone-tech release
button (14) and remove the Cyclone-Tech
unit. Fig. 10
- Empty the contents into a dustbin by pressing
bottom lid release button (26) to open the
bottom lid (25). Fig. 11
- The inside of the container can be wiped clean
by using a damp cloth and then left to dry
before reusing it. To do this, turn the container
lid (23) anti-clock wise to take the container
out of the lid. Fig. 12
- Reassemble the cyclone-tech unit and put it
back on the vacuum cleaner.
Cleaning the motor protection sponge and
HEPA filter (20)
The motor protection sponge (21) and HEPA
filter (20) should be cleaned regularly by
knocking out the dirt and rinsing.
- Press the release button (14) and take the
Cyclone-Tech unit out.
- Remove the sponge (21) from the Cyclone-
tech unit and wash it to clean. Fig. 13
- Take the HEPA filter (20) out and clean it by
tapping or washing. Fig. 14
- Leave both the sponge and HEPA filter to
completely dry before next use.