Fitting The Harness - Stihl FH-KM Notice D'emploi

moving the cutter bar to the transport
position or from the transport position to
the normal working position.
WARNING
The gearbox gets hot during operation.
To reduce the risk of burn injury, do not
touch the gearbox.
FH-KM
1
Shut off the engine.
N
Fit the blade scabbard.
N
Pull back the sliding sleeve (1) and
N
use the lever (2) to swing the joint
upwards – in direction of drive tube
– until the cutter bar is flat against
the drive tube.
Release the sliding sleeve (1) and
N
make sure the lock pin engages the
quadrant (3).

Fitting the Harness

3
The type and style of the harness and
carabiner (spring hook) depend on the
2
market.
Shoulder Strap
Put on the shoulder strap (1).
N
Adjust the length of the strap so that
N
the carabiner (2) is about a hand's
width below your right hip.
English
1
2
9