Measurement - Topcom BPM Wrist 2301b Mode D'emploi

Topcom BPM 2301b
9.3

Measurement

• Press 'POWER'. All digits will light up, checking the display
functions. The checking procedure will complete after about 2
seconds.
• After all symbols disappear, the display will show "0" with the
designated Memory Zone. At this time, the monitor is "Ready to
Measure".
• Press 'PAGE' to select if the result must be stored in memory
zone
• Press 'START'. Once the monitor automatically inflates the cuff
to approximately 180 mmHg, the measurement will begin.
• When the measurement is completed, systolic, diastolic and
the Pulse Rate will be shown simultaneously on the LCD screen
(see §7).
• When a mistake was detected during measurement the Error
mark 'Err' appears on the display (see §12).
• After deflation, the measurement of blood pressures is
completed. Press 'POWER' button to switch off electrical supply.
• If you forget to push the 'POWER' button, the power will turn off
automatically within 3 minutes.
60
or . (see §9.4)