Fermax loft Manuel D'utilisation page 22

Free Access Code (A1)
There is a special "free access" code (initially disabled "0000") that lets you trigger the
relay that activates the door release indefinitely, until the free access code is entered
again. If the code programmed is "0000", this function is disabled.
This function is especially useful when you wish to allow free access to the area to be monitored.
Enable exit pushbutton (A4)
It is possible to equip the system with a pushbutton (P) which, installed inside the
premises, enables the door to be opened from the inside.
These buttons can de enabled or disabled, as follows:
Relay timing (door release activation) (A2)
The relay (which triggers the door release) is initially
The activation time can be changed to any value between 00 and 99 seconds, or in order to
operate in bistable mode (the first valid code activates the relay and the next one deactivates
it):
Pag 8
1º Enter the programming mode:
2º Key in option:
3º Key in the Free Access Code:
Example:
Create a Free Access
Code: 5251
NOTE: If the code length has been changed to a higher number of digits, the free access
code will have been completed with zeros at the end. If it has been changed to a lower
number, the final digits of the code will have disappeared.
1º Enter the programming mode:
2º Key in option:
3º Key in "1" to enable the button
Key in "0" to disable it:
Example:
Enable the exit pushbutton
1ºEnter the programming mode:
2º Key in option:
3º Key in the new activation time or
select bistable mode:
Example:
Change relay timing to 5
seconds.
Master Code (1480)
A1
New Free Access Code
("0000" disables it)
1480 A1 5251
Master Code (1480)
A4
1: Button enabled
0: Button disabled
1480 A4 1
timed to 3 seconds.
Master Code (1480)
A2
00: Bistable mode
01..99: (01 to 99 sec.)
1480 A2 05
beep (x4)
beep (x4)
beep (x4)
beep (x4)
beep (x4)
beep (x4)
beep (x4)
beep (x4)
beep (x4)