Fermax loft Manuel D'utilisation page 19

PROGRAMMING AND CONFIGURATION
The Programming mode lets you modify the configuration and the different system
parameters.
1º) To access programming mode (having previously
been in normal mode), enter the Master code
(1480 by default).
The system emits "4 beeps" to show you are in
programming mode, and the green LED blinks in a
rapid cycle.
2º) To configure each of the functions (when in
programming
corresponding to the function (for example: "A3"
Code length).
At this point, the system emits 4 "beeps" again, to let
you know that the parameter entered is correct, and
the green LED blinks in a slow cycle.
3º) Following, enter the new value to be assigned to
the selected function (for example: press "6" for
selecting a 6-digit code length).
If the data entered is correct, the system emits 4
"beeps" again and the green LED blinks in a rapid
cycle, indicating that we are back in Programming
Mode.
Enter a new function code to be configured, or
press B to exit "Programming Mode".
To exit Programming Mode at any time, key in BB or wait 20 seconds without activity.
NOTES:
During the whole programming process, if the 'B' key is pressed, it goes back to the beginning
of the programming mode, without making any changes. If 'B' is pressed twice, you will exit the
programming mode.
Once in Programming Mode, you can carry out all the programming operations you wish, with no
need to exit the mode. Remember that after 20 seconds with no activity in this mode, the system
returns to normal mode.
Following, it will be described all the system functions and the configuration steps
for each of them.
mode), enter the code
beep (x4)
1 2 3
4 5 6
8 9
7
A 0 B
Key in 1480
beep (x4)
1 2 3
4 5 6
7 8 9
A 0 B
Key in A3
beep (x4)
1 2 3
4 5 6
7 8 9
A 0 B
Key in 6
Pag 5