Change Master Code; Add Or Edit User Codes - Fermax loft Manuel D'utilisation

Change Master code (A0)
The Master Code is necessary to enter the programming mode. The equipment comes
from the factory with a default Master Code (1480). To change it, proceed as follows:
Set the user and Master code lengths (A3)
Initially, the user codes are 4 digits long, including the MASTER code. For enhanced security,
they can be changed to a length of 5 or 6 digits:

Add or edit user codes (00...99)

The codes are stored in the memory in sequence position - code. Up to 100 access codes
can be stored.
Pag 6
1º Enter the programming mode:
2º Key in the option:
3º Indicate the new Master code:
Example:
Programming new access
Master code: 1234.
NOTE: If you forget the Master code, it is possible to reset it with the original 1480, as
explained in the "Reset Master Code" section.
1º Enter the programming mode:
2º Key in the option:
3º Indicate the new length:
Example:
6-digit access and Master codes:
NOTE: Once the user codes are programmed, if their length is changed to a higher number of
digits than the existing codes, additional zeros will be added at the end to adapt to the new
length. If their length is changed to a lower number of digits, the existing codes will have their
final digits truncated.
This will also affect the MASTER Code and Free Access Code.
1º Enter the programming mode:
2º Key in the position in the memory
of the access code:
3º Key in the new access code:
(The code length must coincide with the
one set up in the system).
Example:
New access code 1111 saved in
position 00.
NOTES: If the position to be stored is already in use, the new code will cancel the old one.
It is very important to make a list of the codes and their positions.
Master Code (1480)
A0
New Master Code
1480 A0 1234
Master Code (1480)
A3
4, 5, or 6
1480 A3 6
Master Code(1480)
00...99
New Access Code
1480 00 1111
beep (x4)
beep (x4)
beep (x4)
beep (x4)
beep (x4)
beep (x4)
beep (x4)
beep (x4)
beep (x4)