Decal Installation; Center Of Gravity - Horizon Fitness Hangar9 Carbon Cub 15cc Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

11. Position the wing back on the fuselage as outlined earlier
in this manual. Adjust the ends on the struts so the holes
in the ends line up with the holes in the strut mounting
tab. Slide the pin through the end and tab, then fi t a
silicone tube on the pin. The pins are secured using the
clips as shown in the photo.
12. Check the positioning of the pins and clips as shown in
photos 12 and 13.
Use a hobby knife to trim the silicone tube into 1/8-
inch (3mm) thick pieces so the clips are easier to install.
EN
11.
12.
28

DECAL INSTALLATION

1.
Apply the decals to your model using the photos located in this section of the manual and the box art from your
model. Use a spray bottle and a drop of dish washing liquid or glass cleaner sprayed in the location of the decal to
allow repositioning of the decal. Use a paper towel as a squeegee to remove excess water from under the decal.
Allow the model to rest overnight so the remaining water can evaporate.

CENTER OF GRAVITY

An important part of preparing the aircraft for fl ight is properly balancing the model.
1.
Attach the wing panels to the fuselage. Make sure to connect the leads from the aileron to the appropriate leads
from the receiver. Make sure the leads are not exposed outside the fuselage before tightening the wing bolts. Your
model should be fl ight-ready before balancing.
2.
The recommended Center of Gravity (CG) location for your model is 3
the leading edge at the center of the wing.
3.
When balancing your model, make sure it is assembled and ready for fl ight. Support the plane upright at the
marks made on the wing with your fi ngers or a commercially available balancing stand. This is the correct
balance point for your model.
CAUTION: You must adjust your aircraft's center of
gravity and balance your model properly before attempting fl ights.
15
/
–4
23
/
inches (100–120mm) back from
16
32

Publicité

Table des Matières
loading

Table des Matières