Elevator And Stabilizer Installation - Horizon Fitness Hangar9 Carbon Cub 15cc Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

2.
Slide the wing panel into position, guiding the extensions
from the wing into the fuselage.
3.
Check that the wing fi ts tightly against the fuselage.
4.
Secure the wing panels to the fuselage using M3 x 12
socket head cap screws and M3 washers. Use a 2.5mm
hex wrench to tighten the screws.. Use a drop of canopy
glue on the screw to prevent it from vibrating loose.

ELEVATOR AND STABILIZER INSTALLATION

1.
Slide the stabilizer into the slot in the fuselage. Center the
stabilizer.
2.
Measure from the tip of the stabilizer to the wing. Position
the stabilizer so both measurements are equal. (Cowling
has not been installed at this time.)
EN
2.
3.
4.
1.
A=A
A
A
2.
A
A
A=A
14
3.
Check the alignment of the stabilizer to the wing. It
should be equal on both sides of the fuselage.
4.
Check all alignments. Mark the outline of the fuselage on
the top and bottom of the stabilizer.
5.
Use a ruler and carefully cut the covering 1/8 inch (3
mm) inside the line drawn on the stabilizer to remove
the covering from the center of the stabilizer. Remove
the top and bottom covering. Use care not to cut into the
underlying wood, weakening the stabilizer.
6.
Lightly sand the elevator joiner wire where it contacts
the elevators. Use a paper towel and isopropyl alcohol to
remove any oil or debris from the joiner.
7.
Fit the joiner wire into the elevator halves.
3.
A
A
A=A
4.
5.
6.
7.

Publicité

Table des Matières
loading

Table des Matières