Horizon Fitness Hangar9 Carbon Cub 15cc Manuel D'utilisation page 21

6. Attach the strut assembly to the main gear and the cross
brace. Use the two M3 x 12 socket head cap screws at
the center, and the M3 x 15 socket head cap screws near
the wheels. The screws are secured using M3 locknut,
and tightened using a 2.5mm hex wrench and 5.5mm nut
driver.
7. Slide the M4 wheel collar to the axle. Secure the wheel
collar 1/4 inch (6mm) from the end of the axle using the
M3 setscrew and a 1.5mm hex wrench. Use threadlock
on all metal-to-metal fasteners to prevent them from
vibrating loose.
8. Apply a drop of light machine oil to the axle. Slide the
outer end of the axle into the wheel hub. Fit the hube into
the wheel.
9. Fit a second wheel hub into the wheel over the axle.
10. Assemble the wheel by inserting the four M3 x 25
machine screws through the hub from the outside of the
wheel.
Carbon Cub 15cc
6.
7.
8.
9.
10.
21
11. Use four M3 nuts to secure the wheel hubs together.
Make sure the wheel can rotate freely on the axle. Use a
#2 Phillips screwdriver and 5.5mm nut driver to tighten
the hardware. Use threadlock on all metal-to-metal
fasteners to prevent them from vibrating loose.
12. Attach the hub cap to the wheel using a small amount of
silicone adhesive.
13. Slide the axle into the main gear. Secure it using the M4 x
6 setscrew, tightening the setscrew on the fl at of the axle.
Use a 2mm hex wrench and threadlock when installing
the setscrew. Use threadlock on all metal-to-metal
fasteners to prevent them from vibrating loose.
MOTOR AND BATTERY INSTALLATION
1. Use a #2 Phillips screwdriver and threadlock to attach the
X-mount to the motor. Use threadlock on all metal-to-
metal fasteners to prevent them from vibrating loose.
2. Insert the screws included with the motor through the
holes of the X-mount and into the holes on the motor box.
11.
12.
13.
1.
2.
EN