Horizon Fitness Hangar9 Carbon Cub 15cc Manuel D'utilisation page 12

6. Use a drill and a 1/16-inch (1.5mm) drill bit to drill the
holes for the servo mounting screws in the locations
marked in the previous step.
7. Use a 2mm hex wrench to thread a servo mounting screw
into each of the holes in the aileron servo mounting holes.
Remove the screws before proceeding.
8. Apply a small amount of thin CA to harden the threads
made in the previous step.
9. Check that the servo mount is glued securely to the servo
cover. If the mount is not secure, use a small amount of
15-minute epoxy to make sure the mount is securely
fastened to the servo cover.
10. Secure the servo to the cover using a 2mm hex wrench
and the screws provided with the servo. Center the
servos, then secure the servo arm so it is perpendicular
to the servo centerline. Use side cutters to remove any
arms that do not protrude to the outside of the cover.
EN
6.
7.
8.
9.
10.
12
11. Enlarge the outside hole in the aileron and fl ap servo
arms using a pin vise and 5/64-inch (2mm) drill bit.
12. Secure a 9-inch (230mm) extension to the aileron servo
lead using string or dental fl oss.
13. Tie the string located inside the wing to the end of the
servo lead.
14. Use the string to pull the servo lead through the opening
at the wing root.
15. Repeat the previous two steps to pull the fl ap servo
lead to the wing root. The fl ap servo does not need an
extension to reach the root of the wing panel.
11.
12.
13.
14.
15.