Pontec PondoGarden 3200 Notice D'emploi page 9

Product Description
Overview
 A Description
1 Pressure side connection, G1, female thread
2 Carry handle
3 Motor housing
4 ONOFFswitch
5 Power connection cable
6 Pump foot
7 Pump housing
8 Water drainscrew
9 Suction side connection, G1, female thread
10 Water fillingscrew

The unit contains cast iron, which is subject to a natural corrosion process. This does not impair the function of
the unit.
Intended use
Only use the product described in this manual as follows:
• For transferring water from and draining basins or ponds/pools.
• For irrigating and watering.
• For pumping clear water or rain water.
• Extraction of water from a well.
– Only for irrigation and watering purposes!
• For pumping the water out of water butts/rain barrels or cisterns.
• Operate the product in compliance with the technical data. (→ Technical data)
Possible incorrect use
The following restrictions apply to the unit:
• Do not use for long-term operation (e.g. continuous recirculation of the water in a pond).
• Not suitable for salt water.
• Never use for pumping dirty water/waste water.
• Do not connect to the drinking water supply.
• Not suitable for drinking water.
• Do not use for commercial or industrial purposes.
• Do not use in conjunction with chemicals, foodstuff, easily flammable or explosive substances.
Installation and connection

To reduce pump noise, connect the pump to the pipework via flexible, pressure-resistant hose lines for fixed in-
stallation.

Equip the suction line with a pre-filter and a non-return or foot valve. In addition, fasten the suction hose (e.g. ty-
ing it to a stake) to take its weight off the pump.
• Install the pump in a horizontal and stable position in a dry place.
– For permanent installation of the pump, ensure that a sufficiently large collecting basin can be positioned under-
neath the discharge screw for emptying the pump.
• If possible, install the pump in a higher position than the container/reservoir from which the water is to be pumped. If
this is not possible, a pressure-proof valve must be fitted between the pump and the suction hose.
• Only use vacuum-proof pressure hoses on the pressure and suction side.
 B
• Screw the suction hose and the pressure hose together with the hose connector, hose clip and fitting onto the suc-
tion side (G1) or pressure side (G1) respectively.
- EN -
9