Universal Adapter - Videotec Medusa Manuel D'instructions

Remove the universal adapter for the
speed dome from the aluminium ring,
by undoing the three screws.
Attach the adapter ring inside the housing
using the 4 M4 screws supplied.
Take great care not to pinch or
h
damage the cables there.
Fig. 5
Pass the various wires and cables through the bracket
into the inside of the housing; these cables should
be locked by the cable glands on the plate supplied
with the housing. Then close the plate using the four
self-tapping triangular M3 slotted screws supplied.
Fig. 6
The stretch of cable that is left
h
inside the housing must be long
enough to reach and connect with
the speed dome being installed.
6
Crimp the various connectors onto the cables.
Fig. 7

6.3 Universal adapter

Dismantle the adapter by loosening the
three screws M3x12mm and then taking it
off the ring by turning it anti-clockwise.
Fig. 8
Prepare the camera adapter to the exact
length as given in table then fasten the
speed dome using the supplied screws.