Identification; Product Description And Type Designation; Product Markings; Preparing The Product For Use - Videotec Medusa Manuel D'instructions

4 Identification

4.1 Product description
and type designation
Housing for discreet surveillance that can be used
in both indoor and outdoor installations. It is
designed to be camouflaged with normal lighting
systems. Easy to install, this model is able to house
a range of speed domes. The housing is mounted
with internal cable management bracket; the
bracket can be for wall, ceiling or parapet mount.
A wide range of accessories is available, including:
universal adapter plate for the various speed
dome models, PTC fan heater (single or triple)
and thermostat, camera power supply, sun
protection cover, opening protection alarm.

4.2 Product markings

See the label attached to the outside of the package.
5 Preparing the
product for use
Any change that is not expressly
h
approved by the manufacturer
will invalidate the guarantee.
5.1 Safety precautions
before use
In the 115/230Vac powered configuration
g
it is necessary to insert a 1 0 unipolar
main switch (open contact distance
d>3mm) upstream on the power
line. This switch should be used to
disconnect the power supply before
carrying out any maintenance operation
or before opening the housing.
4

5.2 Contents and unpacking

When the product is delivered, make sure that
the package is intact and that there are no
signs that it has been dropped or scratched.
If there are obvious signs of damage,
contact the supplier immediately.
Keep the packaging in case you need
to send the product for repairs.
Check the contents to make sure they correspond
with the list of materials as below:
Housing packing
• MEDUSA housing
• Housing equipment:
• Cable glands with nuts
• Plate for cable glands
• Gasket for plate
• Screws for plate
• Allen wrench
• Desiccant salt bag
Adapter packing
• Adapter
• Adapter equipment:
• Earthed cables
• Screws for fastening the camera
• Instructions manual
5.3 Safely disposing of
packaging material
The packaging material can all be recycled.
The installer technician will be responsible for
separating the material for disposal, and in
any case for compliance with the legislation
in force where the device is to be used.
Bear in mind that if the material has to be returned
due to a fault, using the original packaging
for its transport is strongly recommended.