Sony CMT-DH5BT Mode D'emploi page 83

There is no sound.
 The USB device is not connected
correctly. Turn off the system, then
reconnect the USB device and check if
"USB MEMORY" appears.
The sound is distorted.
 The bit rate used when encoding the
files was low. Send files encoded with
higher bit rates to the USB device.
There is noise or the sound skips.
 Turn off the system, then reconnect the
USB device.
 The music data itself contains noise.
Noise may have been introduced
when creating music data due to the
conditions of the computer. Create the
music data again.
 When using the USB storage media,
copy the files to your computer, format
the USB storage media in FAT16 or
FAT32 format, and copy the files to the
USB storage media again.*
The USB device cannot be connected
into the (USB) port
 The USB device is being connected
backwards. Connect the USB device in
the correct orientation.

.
The USB storage media which has
been used on another device does
not work.
 It may be recorded in an unsupported
format. If so, first take the precaution
of backing up important files on the
USB storage media by copying them to
your computer hard disk. Next, format
the USB storage media with a FAT16
or FAT32 file system and transfer the
backed-up audio files onto the USB
storage media again.*
"Reading" is displayed for a long
time.
 It may take a while to finish reading the
USB device if there are many folders
or files on it. Thus, we recommend
following these guidelines.
 Total folders on USB device: 100 or
less
 Total files per folder: 100 or less
Erroneous display
 Send the music data to the USB device
again, as the data stored in the USB
device may have been corrupted.
Play does not start.
 Turn off the system, then reconnect the
USB device.
 Connect the USB device that this
system can play.

 Press  (or USB 

unit) to start play.

on the

Continued

GB