Notes
"Passcode" may be called "Passkey, " "PIN
code, " "PIN number" or "Password, " etc.
depending on the device.
This system only supports numerical
passcodes up to 4 digits.
The pairing standby status of the system is
cancelled after about 30 seconds. If pairing is
not successful, redo the procedure from step
1.
While connected to a Bluetooth device, this
system cannot be detected and a connection
cannot be established from another
Bluetooth device.
To erase all the pairing registration
information
1
Press FUNCTION +/
to select "BLUETOOTH" (or press
BLUETOOTH
When the system is connected with a
Bluetooth device (when the Bluetooth
device name or other information
appears in the system display), press
and hold BLUETOOTH OPR
the unit for about 2 seconds to put the
system in Bluetooth standby mode.
2
Press CLEAR
"Delete?" appears.
3
Press ENTER
"Complete!" appears and all the
pairing information is erased.
Note
In order to connect with a Bluetooth device
after performing this operation, you must enter
the passcode again.
0
GB
repeatedly
on the unit).
.
.
Playing music of a Bluetooth device
You can operate a Bluetooth device by
connecting the system and a Bluetooth
device using AVRCP. If the system is not
connected with a Bluetooth device using
AVRCP, "Not In Use" appears when you
operate the system.
1
Select the Bluetooth function.
Press FUNCTION +/
to select "BLUETOOTH" (or press
BLUETOOTH
2
Establish a connection from the
Bluetooth device.
For details about the operations of
the Bluetooth device, refer to the
operation manual supplied with your
Bluetooth device.
Once the connection is established,
the system display changes as follows:
"Connect" Name of the Bluetooth
device
3
on
Start playback.
Press
on the unit).
Depending on the Bluetooth device,
you may need to start up the AV
software of the Bluetooth device
beforehand.
4
Adjust the volume.
Press VOLUME +/
repeatedly
on the unit).
(or BLUETOOTH
.