Additional Information; Troubleshooting - Sony CMT-DH5BT Mode D'emploi

Additional Information

Troubleshooting

Should you encounter a problem with
your system, do the following:
1
Make sure the power cord and
speaker cords are connected
correctly and firmly.
2
Find your problem in the
troubleshooting checklist below and
take the indicated corrective action.
If the problem persists after doing all
of the above, consult your nearest Sony
dealer.
If the STANDBY indicator flashes
Immediately unplug the power cord,
and check the following items.
 If your system has a voltage
selector, is the voltage selector set
to the correct voltage?
 Are you using only the supplied
speakers?
 Is anything blocking the ventilation
holes on the rear of the system?
After the STANDBY indicator
stops flashing, reconnect the power
cord, and turn on the system. If the
issue persists, contact your nearest
Sony dealer.

GB
General
The clock or timer setting is canceled.
 The power cord is disconnected or a
power failure occurred. Redo "Setting
the clock" (page 22). If you have set
the timer, redo "Waking up to music"
(page 70).
"– –:– –" appears in the display.
 A power failure has occurred. Set the
clock (page 22) and timer settings
(page 70) again.
There is no sound.
 Press VOLUME +
 The headphones are connected to the
PHONES jack
 Check the speaker connections
(page 18).
 The system is in pause mode, in Slow-
motion Play or in Lock Search. Press

start the playback.
 If the BLUETOOTH indicator
or flashing when a function other than
the Bluetooth function is selected, no
sound is heard through the speakers
or PHONES jack
BLUETOOTH OPR
2 seconds until the BLUETOOTH
indicator


repeatedly.

.
 (or DVD  

. Press and hold


turns off.
on the unit) to

is lit
for about