Sony CMT-DH5BT Mode D'emploi page 59

Pairing this system with a Bluetooth
device
Pairing is an operation where Bluetooth
devices register with each other
beforehand. Use the procedure below
to pair the system with your Bluetooth
device. Once a pairing operation is
performed, it does not need to be
performed again. If pairing is already
completed, proceed to "Playing music of
a Bluetooth device" (page 60).
1
Place the Bluetooth device to be
connected to this system within
1 meter of the system.
2
Select the Bluetooth function.
Press FUNCTION +/
to select "BLUETOOTH" (or press
BLUETOOTH 
3
Operate the Bluetooth device
and perform the pairing
operation.
For details about the operations of
the Bluetooth device, refer to the
operation manual supplied with your
Bluetooth device.
When searching for this system
with the Bluetooth device, a list of
the devices found may appear in the
Bluetooth device display depending
on the type of Bluetooth device.
This system appears as
"CMT-DH5BT. "

repeatedly

on the unit).
When establishing a connection with
this system, select the audio profile
(A2DP, AVRCP) at the Bluetooth
device. If the Bluetooth device does
not support the AVRCP profile, you
cannot perform playback or other
operations with the system (page 58).
4
Enter the passcode.
Passcode entry may be required
depending on the type of Bluetooth
device.
When "PIN?" and a countdown
appear, enter the passcode at the
system as follows:
Press the numeric buttons

and /
+/
the unit) to enter the same passcode
that was entered at the Bluetooth
device, and then press ENTER
BLUETOOTH OPR
Once pairing is completed and the
connection is established, the system
display changes as follows:
"Connect"  Name of the Bluetooth
device
To cancel passcode entry partway

Press 
.

(or

on

(or

on the unit).

Continued

GB