Mounting And Removing Tip; Operating Procedures - BRASSELER USA Forza V3 Manuel D'utilisation

5. MOUNTING AND REMOVING TIP

Place tip on the threaded post of the handpiece and turn lightly by hand.
Insert Tip through the bottom hole of the Tip wrench. Align the four corners of the Tip base area into the four corners of Tip Wrench.
And turn it clockwise until it clicks.
To avoid injury, do not touch the top part of the Tip.
To remove the Tip, turn it counterclockwise with the Tip Wrench.
CAUTION FOR TIP USAGE
• Before using check the tip for damage, bending or rust.
• Do not exceed Maximum Power Level for Tip. Damage to tooth structure and Tip may result.
• Do not hit metal or prosthetic crown, except for removing them. Tip could break and fall into mouth.
• Do not hit gingival, mucosa and/or skin directly. It could cause damage and/or burn injury.
• Do not sharpen and/or bend the Tip. Tip may damage and not generate enough vibration during scaling.
• During cutting, Tip will gradually wear away. As the Tip wears, the stroke will get smaller and decrease cutting effi ciency. When level
drops too far, change the Tip. ( Tip Card check ) (Fig.11)
• When securing the Tip, use the Tip Wrench or ineffi cient cutting will result.
• Before attaching Tip, ensure the Tip post is free of debris or ineffi cient cutting will result.
• To avoid personal injury ENSURE the Tip is removed prior to disconnecting the handpiece or the handpiece cord.
• If you feel the Tip is not vibrating, remove it from an operative site, and press the Foot Control again. If this does not improve the
condition, Ensure the Tip is secure, turn the power off and restart it.
• Ensure that water volume is at "0", when using a Tip without water ports.
• Tip Wrench is disposable component. For reliable operation replace annually.

6. OPERATING PROCEDURES

6-1 POWER ON ( Fig.8 )
Connect the AC Cord to the wall outlet. Rotate the Power/Volume Knob on the Control Unit. ( Power indicator will light on )
Tighten
Power
Indicator
Tip Wrench
Loosen
7
Loosen Tighten
Fig.8
Fig.7