Mounting And Removing The Handpiece - BRASSELER USA Forza V3 Manuel D'utilisation

3-4 HANDPIECE HOLDER ( Fig.3 )
The handpiece holder attached to the Control Unit keeps the
handpiece in place when it is not in use. To mount the Handpiece
Holder on a vertical surface follow the procedures below.
Make a 3 mm hole in the Double-Face tape behind the screw hole
in handpiece holder.
On the vertical surface make a 3.2~3.5 mm hole in the plate where
the holder will be mounted. Align the hole with the screw hole on
the holder. Make certain the surface is clean then adhere the holder
to the plate, and attach. Insert the Set Screw through the two holes
on the holder and the plate. Fasten the Set Screw with the Nut from
the rear of the plate.
3-5 HANDPIECE CORD HOLDER AND CONTROL UNIT HOLDER
( Fig.4 )
The Control Unit can be attached to the chair unit using the control unit holder.
Align the chaser and Slide the Control Unit into the Control
Unit Holder.
Tuck the Handpiece Cord into Handpiece Cord Bracket.
Make two 3.2-3.5mm holes in the mounting surface. Insert the set
screw in the hole from the holder side and secure it with the nut.
CAUTION
• Do not pull the Handpiece cord with force as it might cause the water
tube inside of the Handpiece to bend and result in improper water fl ow.
• You can mount Control Unit Bracket on the Top Surface or Bottom Surface.
3-6 RUBBER PAD
When using the Control Unit on a stand, make sure to attach rubber
pads to the Control Unit before use to prevent slipping. To stop slipping
the Control Unit on the table, mount the Rubber Pad at the bottom of it.
Clean bottom of the Control Unit.
Fit the Rubber Pad to the appropriate place. (Fig.5)
CAUTION
Control Unit Bracket can not be mounted on the bottom suface if the
rubber pads are attached.

4. MOUNTING AND REMOVING THE HANDPIECE

Align the Dots on the Handpiece and the Handpiece Cord.
Push handpiece into connector.
To remove the handpiece, grip the handpiece and plug of the
handpiece cord then pull straight out. ( Fig.6 )
WARNING
To avoid Electrical Shock DO NOT touch the handpiece
backend electrical contacts.
CAUTION
Always confi rm that the handpiece is correctly seated and locked into place.
Double-
Handpiece
Faced Tape
Holder
Screw
Hole
Make a hole after a screw hole
(about 3.0mm in diameter)
Nut
Control Unit
Holder
Chaser
Rubber
Pad
Handpiece backend
Handpiece
6
Handpiece
Holder
Set Screw
(3.2~3.5mm in
Drill a hole
(3.2~3.5mm in diameter)
Handpiece
Set Screw
Cord
Holder
Handpiece
Chaser
Dots
Handpiece Cord
Nut
Drill a hole
diameter)
Fig.3
Cord
Fig.4
Fig.5
Fig.6