Publicité
Les langues disponibles
Les langues disponibles
GLASSES POSITIONING
In order to obtain a successful dishwashing, it is
suitable to take care of the way dishes are
placed. It is suitable to place glasses, inside the
wire basket with the concave side towards the
bottom. Place mixed cutlery in a vertical
position into the suitable container minding not
to cram them and with hafts towards the bottom
(see the drawing).
REGENERATING
(for machines with Water softener)
If the glass washer is equipped with a Water
softener it is possible to regenerate the resins.
When this operation is needed, the "F" lamp blinks
slowly.
To perform the REGENERATION operation, lift
the overflow out of the tank
completely empty.
( Attention: as far as machines with drain pump are
concerned, see the instructions in the specific
paragraph to unload the tank).
When
the
tank
is
disconnected, close the door.
Push the "B" button fot three seconds until the
"F" lamp is lighted. After twenty (20) minutes
the "F" lamp is OFF.
The regeneration of resins has been completed
automatically and the machine is ready to operate
again.
After 45 washing cycles, this signaling is implicit.
According to the water hardness, it is possibile to
modify the programming of the regeneration. See the
corresponding table in the installer section.
and wait for this to be
empty
and
the
overflow
SALT CONTROL
When it is necessary to add salt in the container, the
"F" lamp blinks quickly.
This operation is programmed to be performed every
10 regeneration cycles.
Unscrew the plug of the salt container at the
bottom of the tank and put 1 kg coarse salt tablets
in it. Clean the gasket and screw the plug.
After having added the salt into the container, perform
the REGENERATION operation by following the
instructions indicated in the previous paragraph.
Attention!
The lack of salt in the container damages the
machine because of limestone, besides a
defective washing of glasses and dishes.
These damages are not covered by the warranty.
RINSING ADDITIVES
To grant a perfect rinsing, a quick drying and to
avoid calcareous sediments on glasses and
cups you must add a surfactant on water
(Brightener).
Your cleansing agent supplier will be able to
suggest
the
most
machine is equipped with a rinse aid dispenser.
Mean concentration used is 0,15 g/lt.
DRAIN PUMP INSTRUCTION
(only for machines with drain pump)
The drain pump starts up automatically just
during the washing cycle to discharge the
exceeding water coming from the rinsing cycle.
At the end of the working day, in order to
completely discharge the tank, it is necessary
to perform the following operations:
1. Open the door of the dishwasher
2. Remove the overflow pipe from the tank;
3
Afterwards push button "P" for 3 seconds.
(the lamp "H" is lighted).
The discharge will stop automatically after 5
minutes. The control lamp will stop flashing.
Reinstall the flow over and shut the door.
(see also the paragraph "Daily maintenance" on
page 23)
22
suitable
product.
Your
Publicité
