Heater Control - SEAL 62S Manuel D'utilisation

Forward indicator (10), LED;
The LED will light when the forward mode is selected.
Speed control (11), control knob;
Sets the speed anywhere in a range between 0 and 10 (See specifications for
actual speed range).
Reverse (12), snap pushbutton;
Press and hold for rotation of the rolls in reverse direction.
Reverse indicator (13), LED;
The LED will light when the reverse mode is selected.
5.1.2

Heater control

The heater-control above the control panel regulates the temperature of the upper main
roller.
Figure 10: Heater-control section.
The heat is turned ON and OFF by the 0/I switch (1). Press I to turn the heat ON. The
actual roll temperature (4) is shown on the control display. The heat has a factory defined
temperature range. Within this range the roller temperature can be regulated. The
temperature set point is displayed when the SEL (5) button is pressed, and changed by
pressing the up (6) or down (7) buttons.
Note: When the temperature set point is being displayed, the light by SV (3) is lit. Press
the SEL (5) button again to return to the actual temperature or the the display will return
back automatically in about 20 seconds.
If the actual temperature is lower than the set point temperature, the heat is turned ON and
C1 (2) is lit.
Note: The heated roller needs time to reach its set temperature (e.g. from room
temperature to maximum takes approximately 1 hour). It is recommended to let the
machine run at a low speed, to avoid uneven hot spots.
22 User Manual 62S