Preventive Maintenance; Auto-Grip Shafts; Trouble Shooting - SEAL 62S Manuel D'utilisation

6.2

Preventive maintenance

Our machines are designed in such way that they need little (preventive) maintenance in
addition to the cleaning.
The following checks have to be performed:
• Auto-grip shafts with blocking cords.
6.2.1

Auto-grip shafts

Check the auto-grip mechanism on each shaft.
• The distance (d) between the rubber cords and the edges of the recess should be
8 ± 2.5 mm minimum (the cord must not touch the skew).
d
A
Figure 22: Auto-grip shaft
If not, correct as follows:
• Loosen the clamp (2) with the screw (1) until the cord is free on one side,
• Shorten the cord by approximately 10 mm (0.4 in.),
• Put the end of the cord back underneath the clamp (2),
• Secure it by tightening the screw (1).
6.3

Trouble shooting

During processing wrinkles can show up in the image (1) on the in-feed table (2) and in the
process result (4) on the output table.
The figures below show some examples where it is caused by the main rollers (3) and
gives a possible solution.
Wait until a few meters is processed to see results.
Pressure too high.
Figure 23: Wrinkles due to high pressure.
• Decrease the roller pressure a little (5-10%).
40
3 2 1
B
User Manual 62S