Process Principle - SEAL 62S Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

2.3

Process principle

In all processes the materials are fed through the nip from the front side to be joined
together by pressure and/or temperature.
A process that makes maximum use of the machine is shown in Figure 4. Shown is an
image roll to roll decaling process with a pressure sensitive top and bottom layer.
The top film has a release liner and the bottom layer is without release liner.
Figure 4: Creating Pop-up art, including image supply from roll.
The image that has to be coated on both sides is unwound from a roll on the optional table
mounted media unwind (1) and fed between the main rollers (2) via the in-feed table (3).
The bottom unwind/wind-up shaft (4) is set as a wind-up to roll up the finished product.
When the optional Easy Feed in-feed table is installed, the media trough can be used to
place the image roll.
The top coating film is taken from a supply roll on the (rear) upper unwind shaft (5). The
bottom coating film is taken from a supply roll on the (front) lower unwind/wind-up shaft (6).
When using a pressure sensitive laminate, it often has a release liner (7) that has to be
removed. As in the top half, it runs via a splitter bar (8) where the release liner is removed.
This release liner is rolled up onto a cardboard core placed on the wind-up shaft (9) in the
upper section.
A mounting film has adhesive on both sides and release liner on just one side, and this
has to stay on until the image is mounted. So a mounting film is processed the same way
as a laminate without release liner.
Note:
When using a pressure sensitive laminate without a release liner (like in the bottom
section), it must not run via the splitter bar to avoid adhesive residue getting on this bar.
Because the rear position is needed for the result, the bottom film is taken from the front
position. The unwind/wind-up combi functions in the bottom positions make this exchange
of unwind and wind-up possible.
The upper main roller can be heated (10). Heat sensitive film is fed under the splitter bar
(8) providing maximum contact surface with the heated main roller.
Description
13

Publicité

Table des Matières
loading

Table des Matières