Operating; Process Controls; Control Panel - SEAL 62Base Manuel D'utilisation

5 OPERATING

This chapter describes the function of the controls and indicators, the operating modes, how to set
up and operate the machine and a number of applications.
The sections in this chapter are placed in a sequence in which the information is needed for
laminating processes.
For the mounting process the sections 5.3 and 5.4 can be skipped with the exception of setting the
pressure (see section 5.4.5).
5.1

Process controls

This section gives an overview of the functions of the controls on the control panel (Figure 7) and
elsewhere on the machine (Figure 8).
Note:
Switch on the heat assist approximately 15 minutes before use, if a process requires the rollers
to be heated. Close the nip and let the machine run at low speed, to avoid uneven hot spots.

5.1.1 Control panel

This paragraph describes the controls and indicators on the control panel.
Figure 7: Control panel
Control ON/OFF (1), toggle pushbutton and standby or ON indication LED;
Press the switch 1 second to switch the machine from stand by to active and back.
The LED flashes when the machine is in stand-by mode.
WARNING:
THE MACHINE IS CONSTANTLY POWERED WHEN THE POWER CORD
IS PLUGGED IN.
Operating 15