Result To Roll Or Roll To Roll - SEAL 62S Manuel D'utilisation

If the film has a release liner (B):
•
Peel off the release liner and pull it over the wind-up shaft,
•
Stick it from above onto the cylinder on the wind-up shaft.
7. Lower the in-feed table.
8. Push the films with a leader panel (C) into the nip using slow mode (B).
Note:
Use a leader panel of the same material, thickness and width as the panels to process.
Use a release board when processing thin images.
5.4.3

Result to Roll or Roll to roll

When webbing for a result to roll or roll to roll (R2R) process, the lower rear unwind/wind-
up shaft is used to wind-up the result.
The laminates are webbed as described above.
Figure 20: Webbing image from roll to roll.
Single sided lamination;
When laminating single sided the unwind/windup shaft in the front of the lower section can
be used to unwind the images (Figure 20, A).
Double sided lamination;
The unwind/wind-up shaft in the front of the lower section is needed to unwind the botom
lamination film (Figure 20, B and C).
This means in the lower section only a laminate without a release liner can be used and
the Media Unwind option(B) or the media trough of the Easy-feed table (C) is needed to
unwind the images.
Webbing the images;
1. Web the upper and lower section laminates as described in the previous sections.
2. When the release board is through the nip, cut off the board and stick the leading edge
of the result onto the cylinder on the wind-up shaft.
3. Set the tension control for this shaft to wind-up tension.
4. Pull the image to the front and feed it over the in-feed table into the nip.
5. When availlable, use the rollers of the Easy-feed table to enter front edge of the image
roll correctly into the nip.
Operating 35