SEAL 62S Manuel D'utilisation page 26

Unwind/wind-up tension control (5), knob;
By turning this knob clockwise an amount of friction is set between the shaft and
the frame, so this will act as a unwind brake.
Turning the knob counter-clockwise will release the brake.
Turning the knob further counter-clockwise will set an amount of friction between
the shaft and the driving sprocket wheel, so this will act as a coupling between
motor and shaft. The shaft will now act as a wind-up shaft.
Turning the knob clockwise will release the wind-up shaft again.
Wind-up tension control (6), knob;
By turning this knob clockwise an amount of friction is set between the shaft and
the driving sprocket wheel, so this will act as a coupling between motor and wind-
up shaft.
To release the tension, turn the knob counter-clockwise.
In-feed table (7)
The standard in-feed table can swing up around the pivot point at the top of the table arms.
The image guide is attached to the input table and can be removed by shifting it from
underneath its retaining knobs.
Easy-feed table (option)
The Easy-feed table replaces the standard in-feed table when initially ordered from factory.
Figure 12: Easy-feed table controls
The Easy-feed table can swing up around pivot point (P) till it is upside down. In the upper
position it is stopped by the shaft supports and in the lower position by the table stops (M).
The in-feed table has a number of features to help feeding images correctly. Some of
these features can only be used in some of the processes.
The features and their controls (A to M) are described below.
24 User Manual 62S