Programming - socomec ATyS C20 Mode D'emploi

5.2. Programming

• This mode allows product parameters configuration.
• Always accessible in mode (when programmed on an input).
• Always accessible in AUT mode, changeover switch on priority source, priority source being available
• Not accessible when "test off load", "test on load" functions are active or during automatic sequence.
Parameters requiring programming before use:
• type of network
• nominal voltage
• nominal frequency
• control logic
• number of auxiliary contacts.
Accessing programming
Factory code = 1000
1 2
1 2
1 2
1 2
1 2
5.2.1. Phases rotation control
Function available only on source
41NBL network.
If a fault is detected, the source
and the following message is displayed
Press for 3s
To modify the
value of this digit
To access the
other digits
Validate entry
1
in case of 3NBL, 4NBL and
1
is not indicated as available
.
1 2
Navigation
1 2
1 2
1 2
1 2
1 2
Programming exit
Press and hold for 5 s
"validation" push button
V1
OK
V3 V2
5. OPERATION
V1
NOK
V2 V3
ATyS C20 / C30 - Ref. : 532 214 F 45