Aprimatic T2 Instructions Pour L'installation page 9

Safety recommendations
• The manufacturer's instructions must be strictly observed.
• The installer must check the installation and the correct functioning of the device.
• The product must not be used incorrectly or for purposes that are not envisaged.
• The product must not be tampered with or modified in any way.
• Always use original spare parts.
• Cordon off the working area to prevent the access of unauthorised persons.
• Ensure that the working area is clear of obstacles and the floor is not slippery.
• All equipment used must be in good working condition.
• The working area must be sufficiently well lit and free of health hazards.
• Unauthorised persons must not enter the working area.
• The working area must not be left unattended.
Purpose of the manual
This manual was drawn up by the manufacturer and is an integral part of the product.
The information it contains is addressed to expert operators that carry out the installation
and extraordinary maintenance. They must have the specific qualifications and training
to carry out the operations assigned to them correctly and under the maximum safety
conditions. Strict observation of the instructions contained in the manual will ensure
safety, optimum operation and prolonged functioning of the product. To avoid incorrect
manoeuvres and the consequent risk of accidents, it is important to read this manual
carefully, strictly observing the instructions given.
Application range
Device for Aprimatic operators to operate swing gates.
ENGLISH
Contents
1. DESCRIPTION ........................................................................................... 5
1.1 Block diagram of the device ............................................................... 5
2. INSTALLATION ............................................................................................ 5
2.1 Preparation ........................................................................................ 5
2.2 Assembly ........................................................................................... 5
2.3 Electrical connections ........................................................................ 5
3. STARTING UP ............................................................................................. 5
3.1 Functioning tests ............................................................................... 5
3.2 Trimmer adjustment ........................................................................... 6
3.3 Programming ..................................................................................... 6
4. OPERATING CONTROL ............................................................................. 6
4.1 Check that the external devices are operating correctly ..................... 6
Aprimatic S.p.A. • Zona Industriale Fossatone
40060 Villa Fontana • Medicina • Bologna (ITALY)
tel. +39-051.6979511 • fax +39-051.6930396
4