Kitchen (Only Model Brenda And Brenda-E); Fuels; Safety Devices - Bronpi BIO ELSA Instructions D'installation

2.1.2.

KITCHEN (ONLY MODEL BRENDA AND BRENDA-E)

The Brenda and Brenda-E models incorporate in the upper part an area that can be used as a
cooking surface. Heating is produced by direct heat transfer.
The Brenda-E model incorporates a ceramic screen-printed glass where you can place any utensil
for cooking, while the Brenda model incorporates a cast-iron plate covered by sanitary enamel (see
drawing D3) on which you can place directly food for its cooking.
3

FUELS

WARNING!!!
The use of a low quality pellet or any other fuel in disagreement with the specifications mentioned below implies the
cancellation of the warranty and the responsibility bounded to the product
Only wood pellets certified by these standards or certifications should be used :
Standards:
• Ö-Norm M 7135 | Din 51731 | EN-14962-2 (all repealed and included in ISO-17225-2)
• ISO-17225-2
Quality certifications:
• DIN+
• ENplus: On the web site (www.pelletenplus.es) you can check all manufacturers and distributors with certificate.
It is strongly recommended that the pellet is certified with quality certifications because this is the only way to guarantee the
constant quality of the pellet.
Bronpi Calefacción recommends the use of pellets with 6 mm diameter, a maximum longer of 3.5 cm and with a humidity percentage lower
than 8%.
•
STORAGE OF PELLET
In order to guarantee combustion without any problem it is necessary to keep the pellet in a dry ambient.
• PELLET SUPPLY
Open the tank cover on the top of the equipment and empty directly the pellet bag taking care of not overflowing.
In the model Paula, in order to supply the stove, you must open the side cover of the stove with the aid of an utensil (shovel, dispenser, etc) or
directly pouring the fuel which is inside the bag into the tank that is on the side of the stove.
4

SAFETY DEVICES

Bronpi stoves are equipped with various safety systems, which ensure a safe and proper operation and protect both the
product and the user. Below are briefly described some of them. In case of doubt, see section 11 (alarms).
•
SMOKE EXTRACTOR BREAKDOWN
If the extractor stops, the electronic card automatically blocks the fuel supply.
• IGNITION FAILURE
The stove automatically starts the ignition and, if during the ignition the flame does not occur, the stove will show the error "Er12" (ignition
failure).
It is important to remember that before igniting, it is necessary to check that the burner is completely clear and clean.
• BREAKDOWN OF THE FUEL LOADING MOTOR
If the geared motor stops, the stove keeps on working (only the smoke extractor) until the minimum working smoke temperature goes down
and stops.
• TEMPORAL POWER LOSS
After a short power loss, the equipment will restart automatically. However in the event of a lack of electricity the stove may
give off a small amount of smoke inside the room for a period of approximately 3-5 minutes. THIS DOES NOT ENTAIL ANY
HEALTH RISK. This is a reason why Bronpi advises, whenever possible, to connect the primary air inlet pipe to the exterior of
the house in order to assure that the stove does not give off smokes after a short power loss.
• ELECTRICAL PROTECTION
The stove is protected against abrupt electricity oscillations through a general fuse placed in the back part. (4A250V
Retarded) (see drawing D4).
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS 30
D3
ELSA, PAULA, BRENDA AND BRENDA-E
D2
D4