User Mode; Ignition Of The Stove; Stove In Operation; Adjustment Of The Room Temperature - Bronpi BIO ELSA Instructions D'installation

- Step 2
0 0 : 0 0
ESC
   
D49
1 3 : 0 0
ESC
GS
9.4.1.

IGNITION OF THE STOVE

In order to ignite the stove, simply press the key P1 during a few seconds. Firstly, the stove carries out an initial check-up and continues the
ignition process. After this, the display shows different steps of the ignition process (2, 3 and 5) (see drawings D52, D53,D54 and D55).
The maximum duration of the ignition phase is 20 minutes. If after this time there is not flame, the stove will automatically activate the alarm
state and the display will show the alarm message "Er12".
ESC
GS W
9.4.2.

STOVE IN OPERATION

Once certain smoke temperature has been reached, the hot air fan starts working.
Once the ignition phase has been finished properly, the stove enters into "Work"
mode which represents the normal operating mode (see drawing D56).
The display shows the time, the working power and the room temperature.
1 3 : 0 0
ESC
 
GS
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
GS W
9.4.
The normal operation of the display/receiver is described below.
Before switching on the display, the stove state is showed in drawing D51. It only
3
shows the room temperature and the current time.
W
D51
ESC
GS
D52
9.4.3.
Press key P2 or P4 and the display D4 will start flashing. By pressing keys P2 or
P4, it is possible to select the temperature desired for the room (see drawing D57).
After 5 seconds, the new value will be saved and the display will return to the
W
normal state.
D57
0 7 : 5 9
ESC
   U
D50

USER MODE

ESC
W GS
D53
ESC

ADJUSTMENT OF THE ROOM TEMPERATURE

43
GS W
ESC
W GS
D54
1 3 : 0 0
3 0
GS W
ELSA, PAULA, BRENDA AND BRENDA-E
W
D55
D56