Start Up; Baffle Plate Positioning - Bronpi BIO ELSA Instructions D'installation

6

START UP

WARNING!! If your stove has been disconnected from the electrical network long time, it is possible that when you
connect the stove to the net and make the start up the display will show the time 00:00 blinking It means the date and hour
are not adjusted and you will must to proceed to their setting. See point 9.3.5 and 10.4.7.3
The ignition of this kind of equipments is automatic, so, please do not put on the burner any kind of material to ignition.
Before the ignition, follow the next verifications:
It is forbidden to use liquid substances such as alcohol, gasoline, petroleum or similar products. The use of this substance
leads the loss of warranty.
- The electrical cable must be connected to the electrical network (230 Vac) with a socket equipped with earthing system.
- The bipolar switch, placed on the rear side of the stove, must be in position I.
- The pellet tank must be supplied.
- The combustion chamber must be clean.
- The burner must be clean and properly placed.
- The combustion chamber door must be closed correctly. In the Paula model, we also recommend that the oven door is closed so that it
can reach temperature more easily.
- In the Paula model, if you do not want to use the oven, it is necessary to remove the tray and grill from the oven, in order to avoid its
deterioration
During the first ignition could happen that the stove has finished the ignition cycle and there is no flame. In this case the stove automatically
starts an alarm state. This happens because the fuel feeder is empty and needs a moment to fill in. To solve this problem start again the stove
(taking into account the previous considerations ) until the flame appears.
The stove, at the beginning, must be subject to different start-up cycles so that all materials and the paint can complete different elastic
expansions.
At the beginning, it is possible that you note smoke or smell which are typically produced when metals are subject to high temperatures or
when the paint is still fresh. This paint is boiled at 80º C for a few minutes when construction, but it must exceed for a time the temperature of
200 ºC before the adhesion to the metallic surfaces.
Therefore, it is important to adopt these measures during the ignition phase:
1. Assure that there is a good air refill in the place where the equipment is installed.
2. During the firsts ignitions, keep a low power work and the oven lit during at least 6-10 hours continuously.
3. Repeat this operation at least 4-5 times or more, depending on the needs.
4. During the first ignitions, you should not place any object on the equipment and, in particular, on lacquered surfaces. Lacquered
surfaces should not be touched while the equipment is heated.
6.1

BAFFLE PLATE POSITIONING

The baffle plate of the stove is placed inside the combustion chamber. The models Brenda and Brenda-E, do not have baffle plate, so you
won´t find anything inside. For the proper operation of the stove, it has to be placed in the upper part of the combustion chamber by following
the next steps (see drawing D16):
Elsa Model:
Model Paula:
- Place the baffle plate on the lateral and rear vermiculites parts.
- You must insert it turned in order to pass it through the door of the stove. (see drawing D17)
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
D16
35
D17
ELSA, PAULA, BRENDA AND BRENDA-E