Specifications According To The Model; Sydney-T And Petra-T - Bronpi ALHAMBRA Instructions D'installation, D'utilisation Et D'entretien

D18
In the models Oxford, Preston, Derby, Bury and Ordesa, to make the change of the collar
you have to follow the next steps:
1. First of all, remove the baffle plate.
2. Remove the vermiculite pieces (only model Oxford).
3. Later, screw out the cover and the collar, change their position and screw them
again in the new position (see drawing D19).
2.1.

SPECIFICATIONS ACCORDING TO THE MODEL

D20
2.1.1.
The models Sydney-T and Petra-T have a 270 m3/h fan to
improve the heat distribution by the ventilation.
The start and the control of the ventilation is made by the
regulator knob placed on the right back side of the stove (see
drawing D20).
This regulator has the following functions:
- OFF position: the fan is turned off when there is no combustion inside the chamber due to the stove is provided with a thermostat that
controls the fan according to the temperature of the stove.
- ON position: the fan is turned on although there is no combustion inside the chamber.
In any case, you can choose the fan speed by the regulator.
• TURBINE CONNECTION:
In the right back side of the stove you will find the cable that connects to the electricity network.
It is advisable do not cut it in the entire length because this section is useful when needed by changes in electrical components inside.
It is obligated the correct connection of the installation to earth connection.
The installation of the system might be done by skilled labour and qualified under the current rules.
• REPLACEMENT OF THE TURBINE:
The replacement of any electrical component will be done
by the front of the stove. With this you do not have uninstall
the stove and you have to follow the next steps (see
drawing D21).
- First of all, you will have to screw out the screws in
both sides of the fan protection.
- Once you have removed the protection you can
access to the thermostat, the plug connections and
the fan will be available.
- In order to remove the fan you will have to elevate it
and release it from its fixation to the stove.
- Disconnect and replace the damaged element and
reattach everything such as before.
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS

SYDNEY-T AND PETRA-T

20
Rear or top smoke outlet
Some models of stoves can change the place of the
smoke outlet collar because it is easily removable, that
allows to the installer a bigger versatility when it is going
to be installed.
In the model Etna, the smoke outlet collar can be
installed on the top or the rear of the stove. To make the
change of the collar we have to follow the next steps:
1. Remove the back sheet. For this you have to
screw out the 4 screws which links with the rear.
2. Screw out the screws of the baffle plate to
body.
3. Remove the baffle plate.
4. Later, screw out the cover and the collar,
change their position and screw them again in the new
position (see drawing D18).
D19
D21
STOVES