Seasonal Stoppages - Bronpi BIO ELSA Instructions D'installation

Once the upper part is cleaned, it is necessary to clean the smoke register in the lower part of the stove. In order to do this,
it is necessary to open the door of the stove and, later, follow the next steps:
- Extract the register cover by unscrewing the screws. See drawing D29
- Clean the ashes and the soot placed in the register.
- Clean the blades and the case of the extractor. Extract the extractor if necessary. See drawing D30.
- Replace the pieces and check the hermeticism of the register.
In the models Brenda, Brenda-E and Paula, this register is under the ash drawer.
In order to do this, simply open the door of the stove and then carry out the same
operations as above (See drawing D31).
In the Elsa model, there are other two cleaning registers placed on the sides of the
stove:
- In order to clean them, it is necessary to remove the side chambers of the stove.
- These registers are placed on each side of the combustion chamber (see
drawings D32 and 33).
In both cases, follow the next steps:
- Extract the register cover by unscrewing the screws. See drawing D34
- Clean the ashes and the soot placed in the register.
- Replace the pieces and check the hermeticism of the register.
In the Paula model there are also lateral cleaning registers. In order to access
to them, you have to remove the side chambers of the stove and repeat the
previous cleaning operations (See drawing D35).
8.8

SEASONAL STOPPAGES

If the stove will not be used for a long time it is convenient to keep the fuel tank
empty, such as the screw-type conveyor to avoid the fuel compacting. Clean
the stove and the smoke duct, removing the ashes and other residues, close
the stove door. It is recommended to clean the chimney at least once a year.
Meanwhile, check the seals because if they are not in good condition (they do
not adjust to the door), they do not guarantee the proper operation of the stove!
For this reason, it would be necessary to change them. If there is humidity in
the place where the stove is installed, put absorbent salts inside the equipment.
Protect the internal parts with neutral vaseline in order to keep the appearance
overtime.
It is possible to disconnect the stove from the electrical network, but remember
that if it is going to be disconnected for a long time, when you connect it again,
it will show the time 00:00 will appear blinking, and you will need to introduce
again the values of date and time.
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
D29 D30
D32 D33
38
D34
D35
ELSA, PAULA, BRENDA AND BRENDA-E
D31