CTC EcoAir 10 Mode D'emploi page 13

General
The CTC condensation tray has been developed as an
accessory for the CTC EcoAir outdoor air heat pump
and can be fitted to EcoAir models with stands with
adjustable feet. (Cannot be fitted to older EcoAir with
square pipe stands).
The condensation tray collects most of the water that
forms on the EcoAir evaporator during operation and
when defrosting, and it therefore suited for installations
where it is unaccepted to allow all the condence water
on the ground below the EcoAir unit.
Condense water leakage can not completely be eliminated,
but the tray will collect and divert most of the water.
Therefore it is recommended that the CTC EcoAir is
positioned on a lowered surface of macadam or similar.
See the CTC EcoAir Installation and Maintence manual
for more information regarding positioning of the
product. The condensation tray is fitted with an electric
heating coil which keeps the tray ice free at sub zero
outdoor temperatures.
Picture 2
Picture 1
! Note that the condensation tray must be con-
nected to an electrical power supply. If not, the
tray can be damaged under cold conditions. The
Edge taped
before fitting product to which the condensation tray is fitted
can also be damaged.
Grate
13