Decommissioning; Emptying; Storage; Electronic Control - Storch PS 12 Mode D'emploi

Symptom
The pump motor stops.
Pump is not conveying
material, although the
motor is turning.
The pump is not conveying
any/enough material - or
the pump is not building up
enough pressure.

17. Decommissioning

17.1. Emptying

See chapter Cleaning.

17.2. Storage

Store the machine in a covered place.

18. Disposal

The PS 12 consists mainly of high-quality metal.
When you decide to retire the device,
note the following:

19. Accessories

The accessories described in the following are available
for the plaster pump.
Designation
Screw conveyor D 6-3
Screw casing D 6-3
Remote control cable extension 14 m
Plaster hose pack extension NW 25, 10
m
Hose whip-end NW 19 incl. air hose, 2 m 64 06 30
Sponge rubber ball for NW 25
Sponge rubber ball for NW 19
Possible cause
Hardened material in the
pump hopper or screw con-
veyor.
Pump shaft disconnected,
but motor is still turning.
Screw pump worn.
Art. no.
64 06 60
64 06 61
64 06 45
64 06 20
64 05 26
64 05 31
Analysis, remedy
• Run the machine in reverse until the mortar pressure
gauge indicates 0 bar and the material hose is depressuri-
sed.
• Disconnect the motor from the power supply or remove
the connecting cable.
• Remove the hardened material and clean the pump hop-
per or screw conveyor.
• Disconnect the motor from the power supply or remove
the connecting cable. Open the screws on the pump hop-
per and reattach the pump shaft. If necessary, replace the
pump shaft (wear) seal the pump hopper again with the
screws.
• Disconnect the motor from the power supply or remove
the connecting cable. If needed, replace the screw con-
veyor.

17.3. Electronic control

Shut down the electrical control unit as
follows:
• Switch the machine off! To do so, press the main switch
on the machine!
• Disconnect the mains plug!
• Recycle the metal!
• Dispose of the device via a scrap metal dealer or your
local scrap metal collection point!
Designation
Stator oil
Safety cable with PRCD-S switch
Hopper bag roller
Nozzle 6 mm for fine plaster lance
Nozzle 8 mm for fine plaster lance
Nozzle 10 mm for fine plaster lance
Nozzle 13 mm for fine plaster lance
97
Art. no.
64 26 95
60 02 25
64 06 50
64 06 06
64 06 08
64 06 10
64 06 13
Translation of the original instruction