Publicité
Les langues disponibles
Les langues disponibles
Nr. Part name
1
Self tapping screw ST4*18
2
Mounting plate
3
Foot lid
4
Lower body
5
Screw M6*20
6
Ring
7
Base
8
Assembly brackets
Packlist Accessories:
Name accessory
Allen key
Tapping screw ST4*18
Washer
Screw M6*20
PREPARATION:
Remove all the packaging materials and check whether the parts of
1.
your table heater are not damaged. Also check whether all accessories
have been supplied. If something is missing or damaged, contact your
supplier.
prepare a cross head screwdriver.
2.
Read this instruction manual carefully and in total before installation
3.
and use. Keep this instruction manual for future use in case needed.
INSTALLATION:
Put the lower body up-side-down (fig. A). Fix the mounting plate and
4.
the foot lid onto the lower body with the 4 self tapping screws ST4*18.
Lay the base into the base cover (fig. B). Put the two rings on the base
5.
and then fix them with M6*20 screws onto the assembly brackets.
Put the lower body upright (fig. C). Insert the plug from the upper body
6.
into the socket of the lower body. Put the upper body upright on the top
of the lower body. Fix upper body and lower body with the joint boards
15
Nr. Part name
9
10
11
12
13
14
15
16
Qty Name accessory
1
Screw M6*27
4
Joint Board
2
Screw M8*10
2
Upper body
Plug
Socket
Joint board (Model 160:
with tablesupport)
Screw M6*27
Operation button
Table
Screw M8*10
Qty
8
2
4
Publicité
